6
Examples
Items not listed under
Introduction
>
Box Contents
are sold separately.
Note
: These examples show the rear panel used by the TS310, TS312, and TS315 models, though all four
models in the TS3 Series have the same input and output.
Example A
:
One Loudspeaker
Connect a dynamic microphone to the
Input 1
using an XLR or
1/4” (6.35 mm) TRS cable. Connect a guitar with an active
pickup to the
Input 2
using a 1/4” (6.35 mm) TS or TRS cable
(see your guitar’s documentation for cable requirements). For
Input 2
, do not turn the
Volume
knob past the
0 dB
position.
Note
: When using the TS3 Series loudspeaker with a guitar, we
recommend using one with
active pickups
rather than passive
pickups. If you use a guitar with passive pickups, connect it to
an external preamp or direct input (DI) box, and connect the
line-level output to the loudspeaker.
Also, use
dynamic microphones
with the TS3 Series loudspeaker
rather than condenser microphones. If you use a microphone that
re48V of phantom power, connect it to an external
phantom power supply before connecting it to the loudspeaker.
Example B
:
Two Loudspeakers
Connect the left and right output of your DJ mixer, controller, etc. to
Input 1
of each loudspeaker using XLR
or 1/4” (6.35 mm) TRS cables. Do not turn the
Volume
knobs past the
0 dB
position.
Tip
: To send the same mix to both TS3 Series loudspeakers, connect both channels of your DJ mixer, controller,
etc. to the
Input 1
and
Input 2
of one loudspeaker, and then connect that loudspeaker’s
Mix Out
to the
Input 1
of the other loudspeaker. Both TS3 Series loudspeakers will then play identical summed mono mixes.
Microphone
Power Outlet
Guitar
Power Outlet
DJ mixer, controller, etc.
