Alto Professional Stealth Pro, User Manual

Page: 8 / 64

8
Operation
To set up and use your Stealth Pro, follow the steps in this chapter in order . If you are setting up a
system using multiple receivers, set up each receiver one at a time , and keep each receiver powered
on as you set up additional units.
Setting Up the Receiver
Frequency Selection
1.
Use the included mini-XLR to XLR cable to connect the receiver’s Audio Output to your
loudspeaker.
2. Use the included power adapter to connect the receiver’s power connector to your power
source. The receiver will power on automatically.
3. Set the receiver’s channel using one of the following methods:
•
To automatically select a frequency:
i. Press the Scan button to automatically scan for the next available RF channel. The
channel will flash on the Display and the RF meter will show the level of RF congestion
for each scanned channel in real-time.
To exit auto frequency selection at any time during the scanning process, press the Freq
button. Press the L/R , Delay , or SQ buttons to exit Scan mode and enter that respective
mode. The receiver will revert to the last selected frequency.
ii. Once the receiver finds the next available channel with an acceptable RF congestion
level, it will hold that channel and continue flashing the channel number in the display.
During this time you can audition the held channel.
iii. If you need to keep scanning for a different available frequency, press the Up/Down
buttons while the channel is flashing to continue scanning in that direction for the next
available channel.
iv. Press the Scan button to select the auto-scanned frequency
and enter broadcast mode. The RF indicator in the display will
flash, indicating that the selected frequency is being broadcast
to the transmitter via the 2.4 GHz frequency (see image).
If the Scan button is not pressed after 5 minutes, the receiver will exit Scan mode and
revert to the previously selected frequency.
v. Once the transmitter has synced with the receiver (see Setting Up the Transmitter
below), the receiver will automatically stop broadcasting the selected frequency and the
RF indicator will stop flashing. You can exit broadcast mode by pressing the
Scan
button to return to normal operation, or press the L/R , Delay , or SQ buttons to exit
broadcast mode and enter the selected function.