DESIGNER SOLUTIONS
2
PRECAUTIONS / SAFETY WARNINGS 1
Please read this manual carefully before using your
TNP100-HB
Interconnect Box. Keep this manual
handy for future reference. These safety instructions
are to ensure the long life of your
TNP100-HB
and to
prevent fire and shock hazard. Please read them
carefully and heed all warnings.
1.1 GENERAL
•
Unauthorized personnel shall not open the
unit since there are high-voltage
components inside.
•
Qualified ALTINEX service personnel, or
their authorized representatives must
perform all service.
1.2 INSTALLATION
•
For best results, place the
TNP100-HB
Interconnect Box in a dry area away from
dust and moisture.
•
To prevent fire or shock, do not expose this
unit to rain or moisture. Do not place the
TNP100-HB
Interconnect Box in direct
sunlight, near heaters or heat radiating
appliances, or near any liquid. Exposure to
direct sunlight, smoke, or steam can harm
internal components.
•
Handle the
TNP100-HB
Interconnect Box
carefully. Dropping or jarring can damage
internal components.
•
Never place fingers inside the opening on
each side of the unit. This action could
cause serious injury because of the sharp
edges inside of the
TNP100-HB
.
•
Do not place heavy objects on top of the
TNP100-HB
. Do not use excessive force to
push down on the top of the unit.
•
To turn off the main power, disconnect the
power cord, which powers the power socket
on the
TNP100-HB
pop up panel. The
power outlet socket should be installed as
near to the equipment as possible, and
should be easily accessible.
•
We recommend using wall outlets with a
Ground Fault Circuit Interrupter (GFCI) for
maximum protection.
•
Install all cables according to the
instructions. Do not force or pull out any
cable or power cord that is attached to the
TNP100-HB
Interconnect Box.
1.3 CLEANING
•
Surfaces should be cleaned with a dry
cloth. Never use strong detergents or
solvents, such as alcohol or thinner. Do not
use a wet cloth or water to clean the unit.
1.4 FCC / CE NOTICE
•
This device complies with part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
•
This equipment has been tested and found
to comply with the limits for a Class A
digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against
harmful interference when the equipment is
operated in a commercial environment.
This equipment generates, uses, and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instruction manual, may cause harmful
interference to radio communications.
