INTERFACES
8
APPLICATION DIAGRAM
5
INSTALLING YOUR INTERFACE
6
Step 1.
Please attach the Interface on the rack
using the provided rack mount
hardware. The Interface can also be
attached on top or under furniture using
the optional
TM
Series Altinex brackets.
Step 2
.
Before you plug in the power cord to the
unit, please verify that the voltage rating
of 110V/220V which is located on the
FUSE CLIP at the rear of the unit is the
same as the power outlet. (Refer to
section 4-6 for changing voltage)
Step 3.
Connect one end of the input cable
included with the Interface unit to the
video output connector of your computer
and other end to the computer input HD-
15 port of the
VA6834FC.
Step 4.
If needed,
connect the local monitor
output HD-15 connector of the
VA6834FC
to the local monitor using
the appropriate Altinex Local Monitor
cables. It is not necessary to terminate
this output with a termination plug if a
local monitor is not being used.
Step 5.
Connect one end of a BNC cable to
output 1 or 2 of the
VA6834FC.
Connect
the other end to the RGB input on the
projector or monitor. Usually either a 4
BNC or 5 BNC coaxial cable
is used, depending on whether display
devices require Composite SYNC or
H&V SYNC signals.
Step 6.
Make sure that the dip- switches are set
properly. For the desired sync output
format, refer to section 7.
Step 7.
It is recommended that if the Interface
horizontal position control is centered
(turned OFF), the horizontal position of
the image should be adjusted using the
control provided by the monitor or
projector. If still required, the image can
be adjusted using the horizontal position
control dial located on the front of the
VA6834FC
.
CONGRATULATIONS! YOU ARE DONE.
If you experience any problems, please call
1-800-258-4623 or 1-714-990-2300 for
international calls.
Summary of Contents for System Analog Interface VA6834FC
Page 6: ...INTERFACES 5...
Page 7: ...INTERFACES 6...
