MULTI-TASKER
6
INSTALLING YOUR MT103-116
6
Step 1.
Slide the
MT103-116
into an available slot
in the Multi-Tasker™ Enclosure in order to
connect to the bus. Make sure that the
MT103-116
card fits into place. Secure
the card to the Multi-Tasker™ by
tightening the retainer screws located on
the top and bottom of the
MT103-116
card.
Step 2.
The LED on the card panel will turn red
indicating that the card is in full operation.
A green LED indicates that a signal is
present.
Step 3.
Connect a VGA cable from the video
source to the input connector of the
MT103-116
. Connect the output
connectors of the
MT103-116
to the
Receiver through a CAT-5 cable.
TROUBLESHOOTING GUIDE
8
We have carefully tested and have found no
problems in the supplied
MT103-116
; however, we
would like to offer suggestions for the following:
•
8.1 LED IS NOT LIT
•
8.2 NO DISPLAY
8.1. LED IS NOT LIT
A) Cause 1:
Card cage is not plugged in.
Solution:
Plug card cage in. If the LED
lights, the problem is solved. If the
LED is still not lit, see Cause 2.
B) Cause 2: Card is not plugged in all the
way.
Solution:
Push the card in all the way. If
the LED is still not lit, see Cause
3.
C) Cause 3: Card cage slot has a problem.
Solution 1:
Test the card in other slots of
the card cage. If the slot was
damaged, the card may work in
other slots. If other slots work and
the LED lights, the problem is the
card cage slot. The card cage may
require service. Call ALTINEX at
(714) 990-2300. If the other slots do
not work and the LED is still not lit,
see Solution 2.
Solution 2:
Take any other known good card
with an LED and verify that the slot
used is good by seeing if the other
card’s LED lights in that slot. If it
lights, then the original card may be
the source of the problem. Call
ALTINEX at (714) 990-2300.
8.2 NO DISPLAY
A) Cause 1: The source has a problem.
Solution:
Check the source and make sure
that there is a signal present and
all source connections are correct.
If
the source is working and there is
still no display, see Cause 2.
