DISTRIBUTION AMPLIFIERS
5
5
APPLICATION DIAGRAM
5
INSTALLING YOUR DISTRIBUTION
AMPLIFIER
6
Step 1.
Make sure that the proper power supply is
being used with the unit. The use of an
incorrect power supply can result in
equipment damage not covered by
warranty.
Step 2.
Connect the power cord to the unit and
plug it into the power outlet. The power
indicator LED on the front panel will light.
This indicates that the unit is operational.
Step 3.
Connect the high resolution RGsB or
RGBS source to the
DA1912SX
using
coaxial cable with BNC connectors,
making sure that the colors match
correctly. Then connect one or two
monitors or projectors to the output(s) of
the
DA1912SX
. The monitors or
projectors must be scan-rate compatible
with the source signal - the
DA1912SX
does not affect scan rate.
Step 4.
The Input Termination switch should
normally be ON unless the input is being
looped to another unit. If the output cables
are longer than 100 feet, consider using
the Video Level Switch to increase the
gain on the outputs of the
DA1912SX
.
The Sync Level switch should normally be
in the 4V position.
Step 5.
If the image is less than perfect, check all
the connections. The unit is very reliable
and seldom will be the cause of
malfunction. Poor quality cables may
often degrade the performance of the
product. Make sure that the cables used
are coaxial cables and that all pins are in
good condition.
CONGRATULATIONS! YOU ARE DONE.
If you experience any problems, please call
1-800-258-4623 or 1-714-990-2300 for
international calls.
