V-MATRIX
5
INSTALLING YOUR VM2142AU
6
Step 1.
Slide the
VM2142AU
and the
VM2141AU
into available slots in the V-Matrix™
Enclosure. Make sure that the cards fit
into place. Secure the cards to the V-
Matrix™ by tightening the retainer screws
located on the top and bottom of each
cover plate.
Step 2.
Connect audio cables from the audio
source to the input connector of the
VM2141AU
. Connect the output
connectors of the
VM2142AU
to the audio
equipment through an audio cable.
OPERATION
7
The
VM2142AU
will operate successfully as long
as the card is installed properly and other technical
specifications are followed.
TROUBLESHOOTING GUIDE
8
We have carefully tested and have found no
problems in the supplied
VM2142AU
; however, we
would like to offer suggestions for the following
:
•
Make sure that power is connected to the
enclosure and also check to see if the
VM2142AU
is pushed in all the way.
•
If there is no sound, check the source and
make sure that it is working at an appropriate
volume level and all source connections are
correct.
•
Make sure that cables are connected properly.
Also, make sure that the continuity and wiring
are good.
•
Make sure that the destination amplifier is
powered. Set the volume of the destination
amplifier to a reasonable level.
•
Make sure that the source signal level is high
enough so that the destination amplifier does
not have to provide excessive amplification and
thereby distort the signal.
•
If there is problem with the
VM2142AU
please
call ALTINEX at (714) 990-2300.
