Altimium
4K HDBaseT
TM
Repeater
4. Operation
4.1 Unit ID setup
4K HDBaseT
TM
Repeaters can be cascaded up to six in this system. Through the DIP
switcher “
ID PRESET
” to set their ID for distinguishing. For example, the Unit ID of the
first 4K HDBaseT
TM
Repeater is set as 0, and then the second one is set as 1 and so on.
Note: The Unit ID of two or more 4K HDBaseT
TM
Repeaters can be set as same
value for synchronous control.
4.2 RS232 Control
All devices (such as projectors) which are connected to RS232 ports of 4K HDBaseT
TM
Repeaters and HDBaseT Receiver can be controlled by sending RS232 commands via
the control PC. There are three control modes: point-to-point, one-to-many and
one-to-all RS232 control.
4.2.1 RS232 Command Format
①
Fixed value.
②
The Unit ID of the 4K HDBaseT
TM
Repeater, X=1~9/A~F
③
The RS232 port of 4K HDBaseT
TM
Repeater, X=1~3:
1: “RS232-1” port
2: “RS232-2” port
3: Both “RS232-1” and “RS232-2” ports
④
Hexadecimal characters represents the control command data, and the length of
character is unrestricted. For specific commands, please refer to the user manual
of the devices which are needed to be control.
Note: When the value of “XX” is FF, send the command “F1 AA 1F FF ... ...” to control all
devices which are connected to RS232 ports of 4K HDBaseT
TM
Repeaters and
HDBaseT Receiver at the same time.
