Altera Cyclone III FPGA, Reference Manual

Page: 18 / 34

2–10 Reference Manual Altera Corporation
Cyclone III FPGA Starter Board October 2007
Interfaces
Table 2–8 lists HSMC A connector board reference and manufacturing
information.
The HSMC uses the Samtec connector’s header provided on the board.
Figure 2–4 shows the outline of the Samtec header.
Figure 2–4. Samtec Connector’s Header
Table 2–9 lists the HSMC Port A interface pins. Signal names and
directions are relative to the Cyclone III FPGA. (The HSMC is operating
as the host.)
General User Interfaces
To allow you to fully leverage the I/O capabilities of the Cyclone III
device, the following are available on the board (remaining I/Os are
connected to additional board resources):
■
Push buttons: System and user reset, and user-defined push buttons
■
LEDs: Board-specific and user-defined LEDs
Some of the board’s buttons and LEDs have a specific board function
while others are user-defined and are provided to control FPGA designs.
Table 2–8. HSMC A Connector Manufacturing Information
Board Reference Description Manufacturer
Manufacturer
Part Number
J1 High speed
Mezzanine card
connector Samtec ASP-12953-01
2.413
((90 POS / 30 x .7875) + .050)
.78 REF
.626 REF
.036 REF .006 REF
.245 REF
.150 REF
01
02
.285 REF
DP Bank
.571
(29 EQ Spaces @ .0197)