Default Switch and Jumper Settings
This topic shows you how to restore the default factory settings and explains their functions.
Caution:
Do not install or remove jumpers (shunts) while the development board is powered on.
Figure 3-1: Default Switch and Jumper Settings
FMCB
FMCA
Arria 10
SoC
1 2 3 4
ON
1 2 3 4 5 6 7 8
ON
J16
J17
SW1
SW3
J42
J32
J30
1 2 3 4 5 6 7 8
ON
SW2
J3
J5
J4
J7
1 2 3 4
ON
SW4
Note:
The Switch position is represented by the black box.
To restore the switches to their factory default settings, perform these steps:
1.
Set the DIP switch bank (SW1) to match "SW1 DIP Switch Settings" table and the "Default Switch and
Jumper Settings" figure.
Note:
In the following table,
ON
indicates the switch is to the upper position according to the board
orientation as shown in the "Default Switch and Jumper Settings" figure.
3-2
Default Switch and Jumper Settings
UG-20004
2016.03.01
Altera Corporation
Development Board Setup
Send Feedback
