Step 1:
This antenna can be configured with either Horizontal/Vertical
Polarization or +/- 45 Degree Cross-Polarization.
For Horizontal/Vertical polarization, position the Feed Horn so that
the arrow label on the rear of feed horn is vertical and connector
labeled “V POL” is pointing down. Attach it to the Dish using the M4
Fasteners.
For +/- 45 Degree polarization, rotate the feed horn 45° so that the
arrow label on the rear of feed horn is as shown below. Attach it to
the Dish using the M4 Fasteners.
AD5G23M2 Installation Note:
Once feed horn is securely mounted to the dish, attached the
included radome to the front of the dish using the supplied screws.
Step 2:
Position the L-bracket on the
back of the dish as shown
above. Fasten it to the dish with
the 4 bolts provided.
Step 3:
Position the U-bolts around the
pole and feed them through the
mast clamp and L-bracket.
Tighten the nuts onto the U-
bolts to secure the setup to the
pole.
Step 4:
The antenna can be precisely
aimed using the up-down tilt
adjustments on the L-bracket.
Once the antenna is at the
required tilt angle, lock into
place using the nuts on U-bolts.
Step 5:
Connect the radio using the (2) cable assemblies provided with the
antenna.
Up-Down Tilt Adjustments
