ALP-XP800
XPEDITION
7
Responsible Party Name:
Innovative Concepts & Designs
Company address:
107 Trumbull St-F8 2nd Floor
Elizabeth, NJ, 07206 USA
FCC Compliance Statement
This device complies with Part 15 of the FCC
Rules. The operation is subject to the following
two conditions:
(1) This device may not cause harmful
interference, and
(2( This device must accept any interference
received, including interference that may cause
undesired operation.
Note: This equipment has been tested and
found to comply with the limits for a class B
digital device, pursuant to Part 15 of the FCC
Rules. These equipment generates uses and
can radiate radio frequency energy and if
not installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause interference to radio or television
reception, which can be determined by turning
the equipment off and then on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment to a different outlet so
that the equipment and receiver are on different
branch circuits.
• Consult the dealer or an experienced radio/TV
technician for help.
Caution
• All operating instructions should be read before
using this equipment.
• To reduce the risk of electrical shock, do not
open the unit. There are
no user replaceable
parts inside. Please refer servicing to a qualified
Altec Lansing service technician. Do not attempt
to return this equipment to your dealer.
• Do not expose this unit to direct sunlight or to a
heat source such as a radiator or stove.
• This unit should be cleaned only with a damp
cloth. Avoid solvents or other cleaning detergents.
• When moving this equipment, it should be
placed in its original carton and packaging. This
will reduce the risk of damage during transit.
•
Do not expose this unit to heat.
•
Do not use cleaning products or
lubricants on the controls or switches.
Precautions
Please read carefully before proceeding
Always follow the basic precautions listed below
to avoid the possibility of serious injury or even
death from electrical shock, short-circuiting,
damages, fire, or other hazards.
• Read, follow, and retain all instructions:
All the safety and operating instructions should
be read before the product is operated.
• Cleaning:
The product should be cleaned only
with a polishing cloth or a soft dry cloth.
Never clean with furniture wax, benzene, or other
volatile liquids since they may damage the cabinet.
• Do Not Open:
Do not open the device or
attempt to disassemble the internal parts or
modify them in any way. The device contains
no user- serviceable parts. If it should appear to
be malfunctioning, discontinue use immediately
and have it inspected by qualified Altec Lansing
service personnel.
• Replacement Parts:
When replacement
parts are required, be sure the service technician
has used replacement parts specified by the
manufacturer or have the same characteristics as
the original part. Unauthorized substitutions may
result in fire, electric shock, or other hazards.
• Positioning and Transportation:
– Before moving the unit, remove all plugged cables.
– Do not use the speaker’s handles for suspended
installation. Doing so can result in damage or injury.
– Do not expose the device to excessive dust
or vibrations, or extreme cold or heat (such as
in direct sunlight, near a heater) to prevent the
possibility of panel disfiguration or damage to the
internal components.
– Do not place the device in an unstable position
where it may accidentally fall over.
• Connections:
Before connecting the device to
other devices, turn off the power for all devices.
Before turning the power on or off for all devices,
set all volume levels to minimum.
