Alsyvox Botticelli, User Manual, Page: 5 / 26

4.
Always keep the case you are opening with the other under it or something else
with a thickness of 15-20cm to get the right height and put a thick anti-slip rug,
rubber mat or carpet with no possibility to shift close to the cases were the
speaker will touch the floor when you lift it up.
Picture 1 and Photo 1 .
5.
Open the top of the top case and remove it. The speaker is laying flat on the
lower part of the case, with binding posts upward.
Picture 2 and Photo 2 . You
can see that there is a metal sheet magnetic shield on the tweeter (only if you
received the speakers by air), this must be removed and we recommend that
you keep it in the PE bubble packaging to avoid sharp edges to be exposed.
6.
Push the speaker sliding it till the edge of the speaker closer to the binding
posts (lower edge once it will be standing up) is free of the edge of the case.
Picture 3 and Photo 3, be careful to keep the light grey fabric lip
between the speaker and the aluminum edge of the flight case.
7.
Clear off the edge of the PE protective film. Photo 4.
8. Take one of the bases and notice that 3 special washers and 1 standard washer
are already glued in position, take the others and the 7 screws and.
Photo 5.
9.
Prepare the base screwing in the levelers (do not use cups and balls now!) at
the 4 angles of the base and putting the screws in the holes in the position as
shown in the detail of
Photo 5 and 6. This means keeping the base in vertical
position touching the floor and inserting the 4 top screws with one washer on
the outside. The other washers are used as spacer for the optimal vibration
transmission between base and speaker and are already in position. The other 3
lower screws can be inserted later.
10.
Secure the base to the speaker using the 7 screws, tightening them as much as
possible
Photo 7 .
11.
Taking the speaker from the edges in a position far away from the base lift it up
with one leveler touching the floor well protected by the rug or carpet (
Photo
8 ). This rug is not only needed to avoid damages to the floor or the leveler but
also to avoid slipping of the leveler as it would make things way more difficult
and dangerous;
so be careful, no slipping shall occur. To lift the speaker