For Customer Assistance:
www.evolutionlightingllc.com
Made In China
Installation
(as a portable luminaire)
1
Preparing the unit for installation
2
Installing the mounting hardware
3
Installing the
fixture
Carefully unpack and lay all parts on a clean, level surface.
Assemble the tubes (B) to the fixture assembly (A).
4
Adjusting the fixture
The USB port is a charging port. Only plug in devices which
require charging at DC 5V MAX 2100mA.
Move the lamp head to position the light as desired.
Determine the desired location of the fixture making sure you have
access to an electrical outlet and there are no electrical lines or
plumbing where you intend to attach the mounting hardware.
Mark the anchor (AA) locations on wall and drill each hole 7 mm
in diameter.
Insert the anchors (AA) and tap into the wall until secure.
Set two screws (BB) into the anchors (AA) using a screwdriver, leaving
enough exposed to set into the keyhole slots on the fixture assembly.
B
B
B
B
A
Align the keyhole slots on the fixture assembly (A) with the
screws (BB) on wall and then gently push the canopy toward
the wall and slide down until secure.
Attach the plastic clip (CC) to the appropriate location on the
bottom tube (B) and mark the outside edge of the plastic
clip (CC). Unthread the bottom tube (B) and move it away, drill a
hole 7 mm in diameter at the center of this marked location and
install the anchor (AA). Remove the pre-attached
plastic clip (CC)
from the bottom tube (B) and secure it to the anchor (AA) with
the flathead screw (DD).
Slide the bottom tube (B) through the plastic clip (CC) and thread
it to the assembled tubes (B).
BB
AA
2.75in./6.98cm
USB Port
BB
DD
CC
AA
B
CC
B