ALS Brake Wired Install Guide
8
© Alsense Motorsport SRL
4.
Electrical Installation
Depending on the option you have ordered, the sensor will come with either an unterminated
end or a DTM06-4S connector. The mating connector is
DTM04-4P
a.
Unterminated
●
12V – Orange / White
●
GND – Green / White
●
CAN Low – Blue / White
●
CAN High – White
b.
DTM06-4S
●
Pin 1 – GND
●
Pin 2 – 12V
●
Pin 3 – CAN Low
●
Pin 4 – CAN High
CAN Connectivity
Every CAN bus network requires two 120 Ohm resistors placed at each end, as the diagram below
(Rterm = 120 Ohms) shows. If you are not familiar with CAN bus, we recommend that you consult
with a professional. Incorrect installation can damage the devices or produce unsatisfactory
performance.
