Installation guide
4
INSTALLATION SAFETY INSTRUCTIONS
This mount is intended for use with screens up to 40kg/88lbs. Exceeding this weight can result in
instability causing damage or injury. Always use caution when installing.
Do not attempt to install this product until all instructions and warnings have been read and properly understood.
Please keep these instructions for future reference.
Please check carefully to make sure there are no missing or defective parts. Defective parts must never be used.
AlpsAV, its distributors and dealers are not liable or responsible for damage or injury caused by improper installation,
improper use or failure to observe these safety instructions. In such cases, all guarantees will expire.
General
AlpsAV recommends that a professional AV installer or other suitably qualified persons, install this product. Great care
must always be taken during installation as AV equipment is fragile, possibly heavy and easily damaged.
If you do not fully understand the instructions or are not sure how to install this product safely, then please consult a
professional for advice and/or to install this product for you. Failure to mount this product correctly may cause serious
injury or death both during installation and at any time thereafter.
Do not mount any AV equipment that exceeds the specific weight limit of the product you are installing. This weight
limit will be
clearly stated on each product and its packaging and will vary from product to product.
Product location
Please pay careful attention to where this product is located. Check load capacity of wall prior to installation as some
walls are not suitable for installation. Designed for indoor use, this mount is suitable for public or home installation.
If located in a public area, ensure the product is out of the immediate reach of people. If any AV equipment is to be
suspended over the likely path or location of people, then great care must be used, ensuring all equipment is securely
fixed to a wooden stud, concrete block or other permanent structure.
Installing on drywall boards alone will not support the weight of most AV equipment.
When drilling holes in walls it is essential to avoid contact with electrical cables, water or gas pipes, contained within.
Use of a good quality live wire detector and hidden abscess locator is therefore recommended.
Only drill into structures when you are sure it is safe to do so.
Fixing hardware
It is highly recommended that all wall fixings be used where supplied and that the purpose of all hardware is fully
understood.
In some cases, more AV equipment fixing hardware will be supplied to accommodate different models of equipment
and set up configurations.
The installer must be satisfied that any supplied fixing hardware is suitable for each specific installation. If any fixing
screws or included hardware are deemed not sufficient, for a safe installation, then please consult a professional or
your local hardware store.
Hazard limitation
When routing cables take advantage of any built-in cable management features that the product might provide
and ensure that all cables are properly routed and secure. Check to see that any moving aspect of the product
can do so unhindered by any cabling.