5
-EN
Movable display
The movable display may be adjusted to 3 different
angles depending upon user preference.
1
Press the
ANGLE
89
button to adjust the angle of the
movable display.
NOTES
•
The display will close a half minute after the ignition key is
turned to the OFF position.
•
The adjusted angle of the display is stored in memory. There
is no need to re-adjust the angle when the power is turned
back on.
CAUTION
Keep hands (or any other object) away from the display while it
is opening or closing to avoid damage or injury. The back of the
movable display will get very warm under normal operating
conditions. This is not a malfunction. Do not touch.
Adjusting Volume/Balance (Between
Left and Right)/Fader (Between Front
and Rear)
1
Press the
MODE
(Audio Control) knob repeatedly to
choose the desired mode.
Each press changes the modes as follows:
NOTES
•
If the MODE (Audio Control) knob is not rotated within 5
seconds after selecting the BALANCE, or FADER mode, the
unit automatically returns to the VOLUME mode.
•
When the subwoofer is ON, respective levels may be adjusted.
2
Rotate the
MODE
(Audio Control) knob until the
desired sound is obtained in each mode.
NOTE
When the temperature inside the unit rises, the volume may
decrease momentarily. This is not a malfunction.
Display Angle Adjustment
→
BAL.
→
FAD.
→
Vol.
Turning Loudness On/Off
Loudness introduces a special low- and high-frequency
emphasis at low listening levels. This compensates for
the ear's decreased sensitivity to bass and treble sound.
1
Press and hold the
LOUD
button for at least 2 seconds
to activate or deactivate the loudness mode.
The display shows "LOUD" when the loudness mode is
activated.
Defeat
By setting Defeat ON, all previously adjusted in the bass
engine mode and LOUD settings will return to the
factory defaults.
1
Press the
DEFEAT
button for more than 2 seconds to
turn Defeat on.
To cancel Defeat, press the
DEFEAT
button again for
more than 2 seconds.
Switching the Phase of the
Subwoofer Output
You can switch the phase of the subwoofer output to
NORMAL 0° or REVERSE 180°. To select the desired
phase.
1
Press the
bass engine
button to change to the bass
engine mode.
2
Move the
Flipper switch
up or down to select SUB.W.
Press the
OK
button or
MODE
knob to set the SUB.W.
mode.
3
Press the
OK
button or
MODE
knob to change to the
SUB.W. PHASE setting display.
4
Move the
Flipper switch
up or down to select 0°
(NORMAL) or 180° (REVERSE). Press the
OK
button
or
MODE
knob to set.
NOTES
•
If no button is pressed within 10 seconds, the Phase of the
Subwoofer Output setting will be turned off automatically.
•
After 10 seconds from the completion of operation, the system
returns to the normal mode automatically. If the RTN button
is pressed, the display returns to the previous setting
indication.
