OPERATION
1. Put the mist unit in your water container.
2. Connect the mist unit to the transformer.
3.
Fill so the water level is ¾” above the top of the auto switch (water level
sensor)
4. Plug the transformer into the main power supply.
NOTE:
The mist maker only needs TAP WATER, neither distilled water nor pure
water is permitted, otherwise the water-level sensor of the mist maker will not
operate properly when water level is low. This will cause the mist maker to
become exhausted to a point of burn out or function improperly.
GENERAL SUGGESTIONS FOR OPTIMUM USE
1. The mist unit sends up small jets of water while in operation. Your
container should be large enough to prevent water from splashing
outside the container. Do not place the unit where water spillage or
condensation will cause damage to furniture, electronic products or
floors.
2. Use of clean water is recommended. When the water is dirty, change it
with clean water in time (dirty water will affect production the mist).
3. Do not use household abrasive cleaners on any part of the mist unit.
You may clear it with soft cloth in clean water.
MAINTENANCE
1. After operating the mist unit for some time, you may notice a decrease in
the amount of mist produced or it may stop working altogether. At that
time, you should either clean or replace the ceramic disk.
2. Unplug the unit and remove from water container, clean it with soft cloth
in clean water and plug on again.
If this doesn’t work, then replace
ceramic disk.
FUNCTION
MODE
COLOR
ORDER
RED
YELLOW
BLUE
STATUS
Single color
1
●
Keep lighting up the set
color
2
●
3
●
Multi-color
4
●
●
5
●
●
6
●
●
All light up
7
●
●
●
Auto-
changing
color
8
1
●
●
●
Auto-changing
color gently, 40 seconds
per cycle.
2
●
●
3
●
4
●
●
●
5
●
●
6
●
7
●
●
●
8
●
9
●
●
9
●
Lights up each color as
modes 1 to 7 step by
step, 3 seconds per step.
●
●
●
●
●
●
●
●
●
●
●
10
Flashing all above modes automatically
0.8 second per step
SAFETY CAUTION
1. Please verify the voltage rate of the transformer with the local power supply
before use. Use the supplied specify transformer.
2. Put the transformer, the connector and the controller which attached on the
cable in a dry place or use indoor only. Take care that no water can get into the
safety transformer, the connector and the controller on the cable along the
supply line.
3. The safety transformer will heat up when in operation. Make sure there is
sufficient air circulation. Do not cover the housing.
4. Keep electrical appliances out of the reach of children.
5. Never touch the water level sensor.
6. When operating, do not let your body parts such as fingers, touch the ceramic or
put on top of it in
4”, which is not dangerous but can cause local pains.
7. Never touch the safety transformer and the mains plug with your wet hands.
8. Always withdraw the mains plug before touching the miniature nebulizer or
remove it from the water.
9. Avoid placing it in the immediate vicinity of electric appliances or water-sensitive
objects because a few water splashes might be produced (but an optimal anti-
splash guard is available).