8
-EN
Accessory List
• Head Unit ..................................................................................1
• Power Cable ..............................................................................1
• Microphone ..............................................................................1
• Mounting Sleeve ......................................................................1
• Bracket Key ...............................................................................2
• Face Plate ..................................................................................1
• Screw (M5 × 8) ..........................................................................4
• Owner’s Manual..................................................................1 set
Turning Power On and Off
Press
SOURCE
to turn on the unit.
Note
• The unit can be turned on by pressing any other button except
.
Press and hold
SOURCE
for at least 2 seconds to turn
off the unit.
Note
• The first time power is turned on, the volume will start from level 12.
Source Selection
Press
SOURCE
to change the source.
TUNER
DISC
USB AUDIO/IPOD
*1
BT AUDIO
*2
AUXILIARY
*3
TUNER
*1
Only when the iPod/iPhone is connected.
*2
Only when BT AUDIO is set to ON. Refer to “Setting the
BLUETOOTH Connection (BT IN)” on page 21.
*3
Only when AUX SETUP is set to ON. Refer to “Setting the AUX
SETUP Mode” on page 18.
Initial System Start-Up
Be sure to press the
RESET
button when using the unit for the first time,
after changing the car battery, etc.
1
Turn off the unit power.
2
Press
RESET
with a ballpoint pen or similar pointed object.
Adjusting Volume
Turn the
Rotary encoder
until the desired sound is
obtained.
Setting Time
1
Press and hold
AUDIO/SETUP
for at least 2 seconds to
activate the SETUP mode.
2
Turn the
Rotary encoder
to select GENERAL, and then
press
ENTER
.
AUDIO
GENERAL
DISPLAY
IPOD
BLUETOOTH
3
Turn the
Rotary encoder
to select the CLOCK ADJ mode,
and then press
ENTER
.
The time indication will blink.
4
Turn the
Rotary encoder
to adjust the hours while the
time indication is blinking.
5
When the hour has been adjusted, press
ENTER
.
6
Turn the
Rotary encoder
to adjust the minutes while the
time indication is blinking.
7
Press and hold
AUDIO/SETUP
for at least 2 seconds to
return to normal mode.
Notes
• To synchronize the clock to another clock/watch or radio time
announcement, press and hold
ENTER
for at least 2 seconds after
setting the “hour”. Minutes will reset to “00”. If the display shows over
“30” minutes when you do this, the time will advance one hour.
• Pressing
will return to the previous mode.
• Pressing and holding
for at least 2 seconds will return to normal
mode.
• If no operation is performed for 60 seconds, the unit will return to
normal mode automatically.
Getting Started
SOURCE/
/ENTER
AUDIO/SETUP
Rotary encoder
RESET button
Summary of Contents for CDE-W235BT
Page 77: ......
