25
-EN
To prevent external noise from entering the audio system.
•
Locate the unit and route the leads at least 10 cm away from the car harness.
•
Keep the battery power leads as far away from other leads as possible.
•
Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis.
•
If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various noise
suppressors, contact them for further information.
•
Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.
1
Antenna Receptacle
2
Audio Interrupt In Lead (Pink/Black)
Connect this lead to the Audio Interface output of a cellular
phone which provides ground shorting when a call is
received.
3
Remote Turn-On Lead (Blue/White)
Connect this lead to the remote turn-on lead of your
amplifier or signal processor.
4
Dimmer Lead (Orange) (CDE-9828RB only)
This lead may be connected to the vehicle’s instrument
cluster illumination lead. This will enable the vehicle’s
dimmer control to dim the backlighting of the unit.
5
Switched Power Lead (Ignition) (Red)
Connect this lead to an open terminal on the vehicle’s fuse
box or another unused power source which provides (+) 12V
only when the ignition is turned on or in the accessory
position.
6
Ground Lead (Black)
Connect this lead to a good chassis ground on the vehicle.
Make sure the connection is made to bare metal and is
securely fastened using the sheet metal screw provided.
7
Power Antenna Lead (Blue)
Connect this lead to the +B terminal of your power antenna,
if applicable.
• This lead should be used only for controlling the vehicle's power
antenna. Do not use this lead to turn on an amplifier or a signal
processor, etc.
8
Fuse Holder (10A)
9
Battery Lead (Yellow)
Connect this lead to the positive (+) post of the vehicle’s
battery.
!
ISO Power Supply Connector
"
Remote Control Interface Connector
To remote control interface box.
#
Front Output RCA Connectors
RED is right and WHITE is left.
$
Rear Output RCA Connectors
RED is right and WHITE is left.
%
Power Supply Connector
&
Left Rear (+) Speaker Output Lead (Green)
(
Left Rear (–) Speaker Output Lead (Green/Black)
)
Left Front (+) Speaker Output Lead (White)
~
Left Front (–) Speaker Output Lead (White/Black)
+
Right Front (–) Speaker Output Lead (Grey/Black)
,
Right Front (+) Speaker Output Lead (Grey)
-
Right Rear (–) Speaker Output Lead (Violet/Black)
.
Right Rear (+) Speaker Output Lead (Violet)
/
ISO Connector (Speaker Output)
:
Subwoofer Output RCA Connectors
RED is right and WHITE is left.
;
RCA Extension Cable (sold separately)
<
JASO/ISO Antenna Adaptor (Included)
