8
-EN
ALPINE CDE-170E 68-40368Z02-A (EN) 128x182
Getting Started
To cancel the demonstration (DEMO)
display, see page 19.
For the connection/installation, see page
30.
Detaching the Front Panel
You can detach the front panel of this unit to
prevent theft.
1
Press and hold (power)
until the
unit turns off, press the front panel
release button
, then pull the panel
towards you to remove.
Caution alarm
If you turn the ignition switch to the OFF position
without detaching the front panel, the caution
alarm will sound for a few seconds. The alarm will
only sound if the built-in amplifier is used.
Attaching the front panel
Resetting the Unit
Before operating the unit for the first time, or
after replacing the car battery or changing
connections, you must reset the unit.
1
Press
and Number button 6 for more
than 2 seconds.
Note
Resetting the unit will erase the clock setting and some
stored contents.
Switching the FM Tuning Step
Set the FM tuning step of your country.
This setting appears only while the source is off
and the clock is displayed.
1
Press and hold
/SETUP for at least 2
seconds, rotate the control dial to select
[GENERAL], then press it.
2
Rotate the control dial to select [FM
STEP], then press it.
3
Rotate the control dial to select from [FM
STEP 50K] or [FM STEP 100K], then press
it.
4
Press
(back) twice.
The setup is complete.
Setting the Clock
1
Press and hold
/SETUP for at least 2
seconds, rotate the control dial to select
[GENERAL], then press it.
2
Rotate the control dial to select [CLOCK
ADJ], then press it.
The hour indication flashes.
3
Rotate the control dial to adjust the hour
and minute.
To move the digital indication, press
/
.
4
Press ENTER to set the hour and minute.
5
Press
The se
To displa
Press VIEW
Prepar
(CDE-17
You can en
calling de
compatib
phone and
device” if n
connectin
supplied w
Before con
volume of
result.
Pairing
BLUETO
When con
first time,
required. P
devices to
connect tw
phones, o
1
Place
1 m (3
2
Press
secon
[BLUE
3
Rotate
[PAIRI
4
Rotate
DEVIC
it.
flash
mode.
