8
-EN
*
The illustration is for CDE-143EBT/CDE-143EBTTH.
Accessory List
• Head Unit ..................................................................................1
• Power Cable ..............................................................................1
• Microphone ..............................................................................1
• Mounting Sleeve ......................................................................1
• Carrying Case............................................................................1
• Bracket Key ...............................................................................2
• Screw (M5 × 8) ..........................................................................4
• Remote Control ........................................................................1
• Owner’s Manual..................................................................1 set
Turning Power On and Off
Press
SOURCE
to turn on the unit.
Note
• The unit can be turned on by pressing any other button except
and
e
(Release).
Press and hold
SOURCE
for at least 2 seconds to turn
off the unit.
Note
• The first time power is turned on, the volume will start from level 12.
Source Selection
Press
SOURCE
to change the source.
TUNER
DISC
*1
USB AUDIO/iPod
*2
BT AUDIO
*3
AUXILIARY
*4
TUNER
*1
Only for CDE-143EBT/CDE-143EBTTH.
*2
Only when the iPod/iPhone is connected.
*3
Only when BT IN is set to ON. Refer to “Setting the
BLUETOOTH Connection (BT IN)” on page 22.
*4
Only when AUX SETUP is set to ON. Refer to “Setting the AUX
SETUP mode” on page 19.
Detaching and Attaching the Front Panel
1
Turn off the unit power.
2
Press
e
(Release) at the lower left side until the front
panel pops out.
3
Grasp the left side of the front panel and pull it out.
Notes
• The front panel may become hot in normal usage (especially the
connector terminals on the back of the front panel). This is not a
malfunction.
• To protect the front panel, place it in the supplied carrying case.
• When detaching the front panel, do not apply excessive force as it may
result in malfunction.
1
Insert the right side of the front panel into the main unit.
Align the groove on the front panel with the projections
on the main unit.
2
Push the left side of the front panel until it locks firmly into
the main unit.
Notes
• Before attaching the front panel, make sure that there is no dirt or dust
on the connector terminals and no foreign object between the front
panel and the main unit.
• Attach the front panel carefully, holding the sides of the front panel to
avoid pushing buttons by mistake.
Getting Started
SOURCE/
Rotary encoder
Detaching
Attaching
00ALPINE.book Page 8 Friday, November 16, 2012 4:10 PM
