Alpine 6LQ27TRMXX, User Manual

Page: 10 / 11

E N G L I S H | 6
C O M P L I A N C E I N F O R M A T I O N
FCC
NOTE: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference
by one or more of the following measures:—
Reorient or relocate the receiving antenna. —
Increase
the separation between the
equipment and receiver. — Connect the
equipment into an outlet on a circuit different
from that to which the receiver is connected.
— Consult the dealer or an experienced radio/
TV technician for help. CAUTION: Any changes
or modifications not expressly approved by the
party responsible for compliance could void
the user’s authority to operate the equipment.
FCC RADIATION EXPOSURE STATEMENT:
To satisfy FCC RF exposure requirements for
mobile transmitting devices, a separation
distance of 20cm or more should be
maintained between the antenna of this
device and persons during operation.
To ensure compliance, operations at closer
distances than this are not recommended.
This device complies with FCC radiation
exposure limits set forth for an uncontrolled
environment. The device has been evaluated
to meet the general RF exposure requirement.
This device complies with Industry Canada
license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this
device may not cause interference, and (2) this
device
must accept any interference,
including interference that may cause
undesired operation of the device. Under
Industry
Canada regulations, this radio
transmitter may only operate using an antenna
of a type and maximum (or lesser) gain
approved for the transmitter by Industry
Canada.
To reduce potential radio
interference to other users, the antenna type
and its gain should be so chosen that the
equivalent
isotropically radiated power
(e.i.r.p.) is not more than that necessary for
successful communication. The device has
been evaluated to meet general RF exposure
requirement. This Class B digital apparatus
complies with Canadian ICES- 003. Lithium
Battery installed is not intended to be replaced
by the USER. CAUTION: Danger of explosion if
battery is incorrectly replaced. Replace only
with the same or equivalent type. Where the
MAINS plug is used as the disconnect device,
the disconnect device shall remain readily
operable. The device meets the exemption
from the routine evaluation limits in section 2.5
of RSS 102 and compliance with RSS-102 RF
exposure,
users can obtain Canadian
information on RF exposure and compliance.
This product complies with California
Energy Commission efficiency standards for
consumer battery chargers.
EUROPE
Alpine hereby declares that this
device is in compliance with Radio
Equipment Directive 2014 / 53 / EU.
The full text of the EU DoC is available
at the following:
https://www.alpine.com/j/research/do
c/
CANADA
This device complies with Innovation, Science,
and Economic Development Canada’s
licence exempt RSSs. Operation is subject to
the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference,
including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR
d’Industrie
Canada applicables aux appareils radio
exempts de licence. L’exploitation est
autorisée aux deux conditions
suivantes :
1) l’appareil ne doit pas produire de
brouillage;
2) l’appareil doit accepter tout brouillage
radioélectrique
subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
Pour satisfaire aux exigences de la FCC en
matière d’exposition aux radiofréquences
pour les appareils émetteurs mobiles, une
distance de séparation de 20 cm ou plus doit
être respectée entre l’antenne de cet
appareil et les personnes en fonctionnement.
Pour garantir la conformité, les opérations à
des distances plus rapprochées ne sont pas
recommandées.
CHINA
CMIIT ID: XXXXYZNNNNN
KOREA
MSIP-XXX-ABC-12345678901234
MEXICO
IFETEL #: XXXXXXXXX
La operación de este equipo está sujeta a las
siguientes dos condiciones: (1) es posible que
este equipo o dispositivono cause
interferencia perjudicial y (2) este equipo o
dispositivo debe aceptar cualquier
interferencia, incluyendo la que pueda causar
su operación no deseada.
OMAN
RUSSIA
SOUTH AFRICA
OMAN-TRA
X/NNNN/YY
Dyynnnn