9
We reserve the right to modify technical specifications without prior notice.
83054200bUK
© ait-deutschland GmbH
Installation and assembly
Observe the following when performing all work:
NOTICE:
Always comply with applicable accident pre-
vention regulations, statutory regulations, ordi-
nances and directives.
DANGER!
The heat pump or heat pump system may
be installed and assembled only by a quali-
fied technician!
NOTICE:
Observe the sound levels of the respective
model.
Overview “Technical data/scope of delivery”,
“Sound” section and “Sound level” overview.
INSTALLATION LOCATION
ATTENTION
Install the unit only outdoors.
Dimensional drawing and installation plan for re-
spective unit model.
TRANSPORT TO INSTALLATION LOCATION
To prevent damage during transport, always transport
the unit to final installation location in its original packag-
ing, using a lifting truck, forklift or crane.
DANGER!
Several people are required to transport
the unit. Do not underestimate the weight
of the unit.
Overview “Technical data/scope of delivery”,
“General unit data” section.
DANGER!
Unit is not fastened to the wooden pallet.
Danger of tipping over during transport!
This can result in personal injury and dam-
age to the unit.
– Take suitable precautionary measures
to eliminate the danger of tipping.
DANGER!
Make sure to secure unit against slipping
during transport.
ATTENTION
Never use components and hydraulic connec-
tions on the unit for purposes of transport.
ATTENTION
Do not damage the hydraulic connections under
any circumstances.
ATTENTION
Do not tilt the unit more than a maximum
of 45° (in any direction).
INSTALLATION
Place the unit on a solid, level foundation that is capable
of bearing weight. Make sure that the foundation is de-
signed for the weight of the heat pump. Materials that
meet this requirement can be used for the foundation
(concrete, stone slabs, etc.). The ground surface in the
air outlet area of the heat pump must be permeable to
water.
ATTENTION
In the air outlet area the air temperature is ca.
5 K below the ambient temperature. Under cer-
tain climatic conditions, therefore, an ice layer
can form in the air outlet area.
Install the heat pump so that the air blower does
not blow in the direction of footpaths.
DANGER!
Several people are required to install the
unit.
NOTICE.:
Always observe the installation plan for the re-
spective unit model. Note the size and minimum
clearances.
Installation plan for respective unit model.
Summary of Contents for LW 100H-A
Page 74: ......
