not be used on the final product. In these circumstances, the OEM integrator
will be responsible for re-evaluating the end product (including the transmitter)
and obtaining a separate FCC authorization.
End Product Labeling
This transmitter module is authorized only for use in device where the antenna may
be installed such that 20 cm may be maintained between the antenna and users (for
example: Access point, Wireless Router, Notebook, etc.). The final end product
must be labeled in a visible area with the following:
“
Contains TX FCC ID:
RRK2005090049-1
”
.
Manual Information That Must be Included
The OEM integrator has to be aware not to provide information to the end
user regarding how to install or remove this RF module in the users manual of
the end product which integrate this module.
The users manual for OEM integrators must include the following information
in a prominent location
“
IMPORTANT NOTE: To comply with FCC RF exposure compliance
requirements, the antenna used for this transmitter must be installed to
provide a separation distance of at least 20 cm from all persons and must not
be co-located or operating in conjunction with any other antenna or transmitter.
We declare this product is limited in CH1-CH11 for 2.4G band by specific
firmware controlled by the manufacturer and is not user changeable.
If the end product integrating this module is going to be operated in 5.15 ~
5.25GHz frequency range, the following warning statement must be included
in the user manual.
The 5.15 ~ 5.25GHz frequency band in US/Canada is restricted to indoor use only.
