5
TYPICAL WIRING DIAGRAM FOR SINGLE ENTRANCE SYSTEM
WITH S.T.R.™ STYLE CAMERA AND ONE (1) VIDEO RISER
(NO VBV-4 VIDEO DATA DISTRIBUTORS)
Notes:
1. All wiring is #22AWG unless shown otherwise, up to a maximum of 300 feet per wire run.
2. When using a PINHOLE type camera, instead of the standard S.T.R.™ type camera, see the special camera
installation and connection instructions found on page 8, and do not power as shown above.
3. DO NOT CONNECT MORE THAN 10 MONITORS PER RISER/LINE.
4. Observe all local and national electrical and building codes.
5. All terminals and connections shown may not be in the order that they appear on the equipment.
NOTE: Install the KBS-1
video to data converter as
close to camera as pos-
sible.
NOTE: Each KBS-1 must
be powered by a separate
NGC20 power supply
NOTE: Each VBV-4 must
be powered by a separate
NG20 power supply
