Alpha One FALCON SPERBER mini DMX 2000W, Instructions For Use Manual

Page: 14 / 26

- 14 –
Version 2.0 November 2008
Nut for ignitor cable
5. After the anode cable has been reconnected to the ignition rod and fixed with the M8 nut,
the glass holding plate must be refitted.
6. After the illuminant has been replaced, it is necessary to readjust the beam.
3.6 Instruction of beam adjusting
1. Switch on the fixture
2. Use a 17mm wrench tool to adjust all three axis.
Use each screw several times to find the optimal focus point.
The adjustment will take maximum 2 minutes.
Beam Adjustment screw
Attention:
The focus is pre-adjusted, so it is only necessary to turn the 17mm wrench tool only in
small degrees steps without much energy to find the optimum focus point.
All three adjustment screws must be adjusted.