Eagle Series Computer Service Manual
Page 23
DSS-10517-00, Rev. B01
Side Mounting Bracket Removal - All Eagles
Refer to the following steps and illustration to unfasten the main electronics board side mounting bracket
from the Eagle chassis. This procedure is exactly the same for both the standard and Super Eagle chassis.
1. Remove the two Phillips-head screws that secure the main electronics board’s side mounting
bracket to the chassis. Before you slide out the board and its mounting bracket, notice how the
board’s mounting bracket is positioned over the two alignment tabs on the bottom of the chassis.
When you reinstall the assembly, make sure the mounting bracket is properly positioned over
both tabs; if it’s not, it will be impossible to reinstall the two screws that hold the assembly in
place.
2. To remove the main electronics board and its mounting bracket, lift the bracket high enough to
clear the bottom lip on the chassis. Once you clear the bottom lip, pull the entire assembly out
just far enough to disconnect the two DC power connectors that extend between the power
supply and the main electronics board.
POWER SUPPLY
1
2
3
4
5
6
MAIN ELECTRONICS BOARD
MOUNTING BRACKET
To remove the board mounting
assembly, you must remove
these two screws.
Main Electronics Board Side Mounting Bracket Removal
