Alpha Group OutBack Power MATE3, Owner'S Manual

Page: 17 / 160

900-0117-01-00 Rev A
15
Installation
Location Considerations
The following information is important to consider when installing the OutBack MATE3.

The MATE3 is intended for indoor installations only. Installing the MATE3 outdoors could expose it to
damaging environmental conditions. Such damage is not covered by the limited warranty.

Readability of the display is affected by direct sunlight. It should be positioned about “eye-level” for
easier viewing and access.

The MATE3 voltage is less than 30 Vdc and is thus considered a “limited energy circuit” normally
requiring no conduit (consult the local inspector for specific installation requirements). Cable runs
must be protected and runs must be in approved conduit when conditions require and not exposed
to the weather.
IMPORTANT:
Signal degradation can result if cable is run in conduit with AC wiring or in
other electronically “noisy” environments; these can affect the maximum
length the cable can run without incurring transmission errors.
Mounting Considerations
The MATE3 includes (1) OBCAT 6 Cat5 cable with the correct RJ45 connectors already installed. Longer (up
to 1000’) or shorter cables can be purchased pre-made (at home improvement or computer stores).

Cat5 cable is not as strong as standard house wiring and must be handled carefully. Avoid kinking the
cable or tearing its outer sheathing.

Use plastic standoff cable staples, J-hooks, or cable trays to support long runs of Cat5 cable.
Do not splice cables.
Several mounting brackets are sold as accessories for the MATE3. Follow the installation
instructions included with the bracket chosen when mounting the MATE3.
Materials Included

MATE3

SD Memory Card (
1
GB)

6’ CAT5 non-crossover cable

Silicon grease pack

MATE3 System Display and Controller Owner’s Manual ( this manual)