Page 4 • IL498 Tek-VIEW
®
Copyright © TekTone Sound & Signal Mfg., Inc. All Rights Reserved.
Figure 4—Wiring Layout Diagram
WIRE CONNECTIONS AND
EQUIPMENT INSTALLATION
Check all wires for shorts to each other and for grounds.
Connect all wires
(except 117 VAC connections to
transformers)
as shown in the connecting diagram (Figure
5), and in accordance with the wiring instructions. Refer to
Figure 6 for dual entrance wiring.
Entrance Panel (VM320B):
A. Install frame (OF190 series) into housing (OH190 se-
ries).
B. Connect all wires necessary as shown in connecting
diagram (Figure 5). Refer to Figure 6 for dual entrance
wiring.
C. Connect coaxial video cable (RG59U) to the camera
cable connector on the back of the camera. Connect the
remaining wires from the cable connector CN and CP to
supply power.
D. Install the front panels into the frame, following the
directions included with the directory panel.
distances greater than 500', use 20 gauge wire. Maximum
distance from amplifier for communication wires is 1000'.
D. Wire gauge size for selective wire (X) is 22 gauge. Wire
gauge size for camera wires (CP, CN) is 18 gauge. Unless
specified, all other wires are 22 gauge.
E. Use 16 gauge wire to connect control unit to the trans-
former. If wire length is greater than 50', use 14 gauge
wire.
F. Run all power supply wires (+ and -) directly to the
control unit location (usually the entrance panel loca-
tion). For wire length greater than 200', use 16 gauge
wire.
G Use 2 cond., #18 cable for door release wiring. If release
is located more than 50' from the control unit, use #16
wire.
H. The control unit (PK314A) is rated for 3 amps at 17 VDC
and may be used to supply power for up to 50 VM104
monitors. See
System Layout
section for additional infor-
mation. Microphone wiring must be shielded cable, and
the shield must be connected to terminal G.
PK320
PK320
+1 cond. #18