14
telephone number to the GSM Relay Sensor Alarm Switch
while in “Programing” mode. After
calling from the primary notification telephone number, all telephone numbers contained in the SIM
card memory are erased and it will be necessary to re-add all required telephone numbers all over
again.
Attention!
This action resets all settings to the default settings (as shown in Table 4).
2.7
Relay Sensor Alarm Switch Installation
The Relay Sensor Alarm Switch should be installed at a location that will be shielded from
atmospheric elements, physical damage and access by unauthorized persons and will have access
to a reliable GSM signal.
The Relay Sensor Alarm Switch should be located away from high power electrical cables.
Diag. 7- Installation Size Specifications
In order to install the GSM Relay Sensor Alarm Switch, consecutively execute the following steps:
1. Select a location to install the GSM Relay Sensor Alarm Switch.
2. Mark-up the selected installation location bearing in mind measurements and the location of
mounting holes as located on the GSM Relay Sensor Alarm Switch base.
3. Install the GSM Relay Sensor Alarm Switch by removing the cover and the circuit board from the
base. Run and connect wires to terminal block X2 (having previously breaking-out the plastic plugs
from the input openings) and attach the base using two screws, then snap-in the circuit board and
then replace the cover. Double-sided tape can also be used to mount the GSM Relay Sensor Alarm
Switch on to a properly prepared surface.
4. Verify operation in accordance with item 2.5.
5. Fasten the connection wires and attach them to the intended device.
