User Manual
7
2. When connected via AUX, you will need to control volume and music directly
through your phone.
Notes:
•
You only need to perform Step III (Pairing) for the initial setup. After the first successful connection, the speaker will
connect automatically to your device whenever you turn the power on.
•
If you need to connect the speaker to a different device, simply turn off the Bluetooth on the first device.
Alternatively, you can find the speaker on your phone’s list of trusted devices, and delete it from the list. When the
AX320 cannot find the last device it was paired with, it will enter pairing mode again automatically.
Technical Specification:
Bluetooth Specification
Version 4.0 + EDR
Transmission Distance:
< 30ft (10m)
USB Charging Voltage:
DC 5V+ o.5A
Battery Capacity:
500mAh
Output Power:
5 watts
Frequency Response:
90Hz -‐ 20KHz
Sensitivity:
80db + 2db
S/N Ratio:
76db
Troubleshooting:
If you are unable to connect the speaker to your device, follow the steps below:
l
Check if the battery is low. When the battery is low, the speaker may have trouble connecting. Charge the
battery fully and try again.
l
Check the power switch and make sure it is on. When it is on, the LED under the speaker wire mesh will light
up in BLUE for a few seconds.
l
Restart the speaker. Press and hold the power button for 3 seconds to turn off, then press and hold for 3
seconds to turn it back on.
l
Make sure the Bluetooth on your device is enabled.
l
Try removing the pairing by going to the Bluetooth section of your device, choose AX320, and select “Forget
this Device.” Turn Bluetooth off for 3 seconds on your device, and turn it back on. Repeat Step III to attempt
to pair again.
Alpatronix is a registered trademark of
Saritek Technical Solutions, Inc.
PO Box 17070, Anaheim, CA 92806
United States of America
(888) 407 -‐ 7515
Summary of Contents for AX320
Page 2: ...User Manual 2 ...
