Touch screen controller
ALNOR Systemy Wentylacji Sp. z o.o. Knowledge Base | www.alnor.com.pl
4
Bypass
When bypass is on, the bypass symbol appears, when bypass is off, the symbol disappears.
Filter alarm
When running time of ventilator is over the setting filter alarm time, the filter alarm symbol flashes to
remind user clean/replace the air filters. After filters being cleaned/replaced, please sweep the filter
alarm by setting parameter Number 24, value 1.
Parameter setting
Keep pressing the MODE button for 6 seconds, after buzzing to enter the parameter setting interface
After entering the parameter setting interface, press SET button shortly to change the parameter number,
every pressing will increase 1 parameter number (until number 24 then repeat again). After
choosing the correct parameter number, press Mode button for short, parameter value flashes at the
top right corner, at this time to change the value by UP and DOWN buttons. After parameters setting
then press SET button to save.
Attention:
1) After parameters setting, system need around 15 seconds to record, during this period power should
not be off.
2) Please refer to the parameters table to set the suitable parameters according to different requests.
Bypass on
Bypass off
COMM
COMM
Filter alarm
After sweeping filter alarm
COMM
COMM
