8
HEATER
Mount the heater as shown in the heater installation instructions. The heater should be positioned between the benches on
the back end wall approximately 7 inches from the floor. The lower the heater is, the hotter the temperature will be at the
benches. All the necessary hardware is supplied with the heater.
Do not attempt to wire the heater yourself. Contact a licensed electrician in accordance with your local electrical codes.
Figure 5 - Seat Installation
Center Seat Support (6’ and 8’ models only)
Wall Cleat
Use torque screws
BENCHES & SUPPORTS
Each barrel sauna includes two pre-assembled benches. Lay the benches on the lower cleats mounted on each end
wall section. Position the benches so that the pre-drilled holes cover the cleat and screw the bench into place. Install
center supports (on 6' and 8' models only) as shown in illustration. Be sure to sink screw heads below the surface so you
will not burn yourself while using sauna.
(See Figure 5)
. The Grandview and Rustic Saunas include two contoured
back supports. Place the spacers against the installed benches and screw the back supports to the sauna walls.
(See
Figure 5A)
Note for Canopy Barrel:
Assemble the exterior benches as shown below in the
same way you assembled the interior benches. You
will attach an exterior benches wall cleat to the sauna
wall, using
a level to
insure that
the seat is
level.
Bench Support
Bench
Cleat
Figure 5A - Back Support Installation
(Grandview, Huntington, and Rustic Saunas only)
Spacer
Back Support
Use 2” screws
Note for Grandview Barrel
The Grandview Barrel Sauna has duckboard flooring
sections. Place the first section at the door and work
back towards the heater.
Duckboard Floor Section