Tx 92/24 Telephone Expander Installation Guide
3 Wall Mounting (Optional)
Phones connected to Telephone Expander(s) can be mounted on a wall. This requires two wall mounting
plates (not included), one for the phone and one for the last connected telephone expander. Mounting plates
should meet the requirements of standard TIA-570-B, Section 5. The mounting plates are available from your
local telephone company or your local retailer.
Caution: If using a standard telephone wall mounting plate, DO NOT make any connection to the RJ11
jack. This connection is intended for an analog phone and may cause damage to the Allworx
phone, voiding your warranty.
If the phone and/or expander(s) base(s) are attached, then remove the base(s). Attach the wall mount
assembly that was provided with the telephone expander to the last connected telephone expander. The
mounting plates, similar to those shown below, have mounting studs to receive the phone base and are
positioned to secure the phone and telephone expander(s) flush to the wall surface.
Mount the phone and telephone expanders over the mounting plate studs. The back sides of the phone and
telephone expander provides wire channels for power and network (RJ45) cables.
To make mounting the phone and telephone expander to the wall easier, a template can be obtained at our
website (
www.allworx.com/support/downloads/default.asp
, select the Documentation link).
Leviton 4108W-0SP
300 Main Street • East Rochester, NY 14445 • Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com
© 2008 Allworx. All rights reserved
Version 2. Revised: October 31, 2008
Page 6
