WARNING
- The motor time of start is istantaneous when the door is on the end-run, the movement reversal time of
the door out of the end-run (and also of starting) is regulated by the Dip-switch “SW2”.
Inserting the photocell contact (N.C.) in this control, control the the right functionnement otherwise the
control will not close or will always be on block (Autotest).
Always check the signalling leds before of every intervention.
On this control it is possibile to insert (SW1 dip 2) the function anti-dragging : with close end-run ope-
ned and the low and/or Hihgt photocell obscurated, an impulse of open does not give movement.
In case of damage of the photocells it is possible to make the control working only with “Pressed But-
ton” (SW1 dip 3) for opening and closing movement.
First intervention on Control drawbacks
Problem
Likely Cause
Solution
Control does not move, switched off
leds
Control does not move, switched off
leds
Control doesn’t move, DL10 led light
Control doesn’t close, DL8-9 led light
Control goes on with opening or don’t
close in automatic
Control opens a little and then stops
Control opens but does not reclose
Control does not feel end-run of open
and close
Control gives movement only in one
directon
Control reverse with low photocell
when the motor opens
The motor does not open the door com-
pletely
Control close at once
Control reverse the movement bru-
squely
Photocell stops on Open
Control does not open
Control does not open
Times too long
Wrong connection line 18V, check
Fuse F5.
Short-circuit on output 24Vdc. Check
F5.
Block contact opened
photocell enter opened
Open button always pressed (led DL3
or DL5 or DL6 lighted)
Safety profile, block, end-run
Semiautomatic function insert
Wrong connection of the end-run
Wrong connection of the Common
wire of the end-run
Wrong connection of the motor
(reverse 2 phases)
“Working” time too short
“Pause” time short
“Reversal” time short
P.L. function inserted
Failured of the hight or low photocell
autotest
Anti-dragging acrivated (SW1 Dip 2)
Time Regulations SW1
Insert supply like in the scheme
Disconnect the controls supplyed from
the gate-opener and check wires.
Check that the block is N.C.
Check that the enters are N.C.
Check all the enters (buttons, Rx radio,
magnetic spool)
Check that there are not false contacts
Select function (DL7)
Connect in the right way
Connect in the right way
Connect in the right way
Increase the “Time of working”
trimmer (P1)
Increase the “Time of pause” trimmer
(P2)
Set the “Reversal Time” (SW2)
Check Dip 1 (OFF)
Check the photocells
Check the photocells
Set in the right way
The Alltronic s.n.c. will not be responsabile for wrong connections and/or mishandlings of the
control which will not be considered under guarantee.
