Alltech KEENAN MechFiber380, Operator'S Manual

Page: 17 / 73

KEENAN
MechFiber380 Operator’s Manual
Revision D02 09
th
Sept 2020
17
7.3 Diet feeder capacity
Due to the diversity of the materials available for feeding, as well as to the KEENAN
MechFiber
’s ability to incorporate a wide range of feed types into the ration, the capacity of
the machine will vary. Ensure that overloading is avoided at all times, as mix quality could
be seriously affected as a result and the machine could potentially be damaged.
Overloading must be avoided because:
• The mix will not be homogenous (evenly mixed), preventing the machine from providing
the maximum benefits.
• Mechanical failure will result. Due to the nature of the loading, this may occur at load
levels below those that would break the shear bolt.
The overall amount of material that can be chopped/mixed in one load depends on the
following:
• Machine size.
• Overall dry matter of the TMR.
• The chop length and quality of the material added.
• The loading procedure and loading order of the materials used (e.g., the addition of straw
first or last), which has a major effect on machine capacity.
• Tractor H.P. rating.
CAUTION:
The machine can be overloaded before the shear bolt breaks. Therefore, not
breaking a shear bolt is not necessarily an indication that the machine is not
being overloaded.
Figure 6: Photograph illustrates a well-mixed
ration, showing consistent fibre length and
the integration of forages and grains.