1 December 2017
8
P+JAssem Version 1.1
•
On the guitar body edges
•
2 strap button pilot holes
•
On the neck heel:
•
2 neck mounting pilot holes
•
On the headstock
•
16 tuner screw pilot holes
4.4.
Neck Attachment
Start with the body resting on a sturdy, flat, soft surface.
•LOOK AT AND UNDERSTAND THE PICTURES.
The neck should only be inserted from the top, not
from the end. The neck widens as you approach the
end, so it does not fit into the front of the slot.
(Figure 15)
•Attempting to insert the neck from the end can
result in damaging the body and/or neck. (Figure
14) DO NOT DO THIS!!!!
•
Ensure the neck sits flat and against the body. The fit will be snug but not tight.
•Once the neck is in place, gently turn the guitar over
and lay on its face. Be sure to hold the neck and
body together firmly while you turn the guitar over.
You don’t want to twist the neck as this can damage
the neck or body.
•Place the neck plate (with the countersunk holes
facing up) on the neck and align the 4 holes. (Figure
16)
•DO NOT USE A POWERSCREWDRIVER!
Troubleshooting!
•
If the neck does not fit flat against the body, remove and ensure the neck slot is clean and free of
debris. Ensure the neck is clean and free of debris and finish.
•
If the neck does not fit into the slot, check the clearance on each side. Sometimes light sanding is
required on the neck to place into the slot. The fit is very snug by design and wood can expand and
contract depending on weather conditions.
•
If the neck is not fitting , check both the neck and body for any raised grain areas, extra paint or
gloss. (Finish coats may be thicker than you think!)
•
Using #320 or #400 sandpaper, remove any excess finish that is affecting the neck fit. DO NOT
OVERSAND! FIT SHOULD BE SNUG!
Alloy Pro T
ip
Neck screws are big and long
and can be difficult to drive,
even with pilot holes. To make it
easier, rub the screw threads on
the soap or candle to add a little
non-oil based lubricant.
Al
loy Pro T
ip
This is where caring and
patience really count! DO NOT
USE A POWER SCREWDRIVER!
If using an electric screw driver
to install the body screws, stop
well before the end of the screw.
Complete the install by hand
with a good, well fitting
screwdriver.
