4 of 5
3.
Setup the COM port properties by using the information below and click “OK”.
Bits Rate per Second = 9600
Data Bits = 8
Parity = None
Stop Bit = 1
Flow Control = None
4.
Connect the included serial cable from the computer’s COM port to the Switch’s
console port.
5.
Power on the Switch and you will see some messages displayed in the
“HypertTerminal” window. The Switch’s Power On Self Diagnostic (POSD) takes
about 100 seconds. After that, you will be presented with the login screen.
If the Switch is already powered on and finished its self-diagnostic, after running the
terminal communication program, please hit “Enter” once to get the login screen.
6.
At “username” field type in
admin
and hit “Enter”.
7.
At “password” field type in
admin
and hit “Enter”. You are now logged into the
Switch’s configuration program.
8.
On the lower portion of the screen, you will see descriptions of the navigation keys
(e.g. Tab, Space Bar, and Enter). Please use these keys to move around the
configuration program.
For more information about the configuration settings, please refer to the User’s Guide on
the CD-ROM.
Note:
If there is no activity for 2 minutes the console program will automatically logout.
Please reenter the password and username to login.
In-Band Configuration via Ethernet Network
In addition to terminal mode configuration, the EMS-24T02M Switch also supports In-Band
Configuration using a Web Browser. You can simply connect a network-ready PC to the
Switch, open your web browser, go to the Switch’s configuration page (Switch’s IP address),
and configure the Switch by clicking the appropriate menu items.
Before you can access the switch through in-band, you must make sure the computer
connecting to the Switch has a web browser and the TCP/IP protocol (with valid IP address) is
bound to the network adapter. After that, you can either change your computer’s IP address to
the same class as the Switch’s IP address, or you can login to the Switch with the
“out-of-band” method described in the previous section and configure the Switch’s IP address
to the same class as your computer’s IP address.
Below, is the Switch’s default IP information:
IP Address: 192.168.0.100
Subnet Mask: 255.255.255.0
Gateway: 192.168.0.1
