NICE HSRE12
families:
INSTRUCTIONS
Visit our Website. www.alloremotecontrol.com
To enable the control devices to activate the outputs of HSRE12, the device codes
must be memorised on the receiver.
Memorising devices on the HSRE12 receiver:
To memorise a device, proceed as follows:
01.Press S1 (PROG) to activate programming mode; a BEEP indicates the start of
programming;
02. Select the required output by pressing S2 repeatedly (SEL.CAN); the relative led
of the ALL output illuminates;
03. Memorise one or more devices for each output, performing the action specified in
Table 1;
04. A BEEP confirms correct programming, 3 BEEPS indicate that the device has
already been memorised;
05. To memorise other devices on other outputs, repeat points 02 and 03;
06. The memorisation phase terminates by pressing S1 and S2 simultaneously or after
1 minute of inactivity.
Caution! It is not possible to memorise devices with a timed function
together with devices with an ON-OFF function on the same output.
Visit our website: www.Alloremotecontrol.com
