44
iSCSI CRC/Checksum
To enable this option, the initiator can connect with “Data digest” and “Header
digest” enabled.
Network Management
Use the Network menu to make network configuration settings as well as service
support settings.
WAN Configuration
From the Network menu, choose WAN,
and the WAN Configuration screen
appears. This screen displays the
network parameters of the WAN
connection. You may change any of
these items and press Apply to confirm
your settings. See a description of each
item in the following table:
WAN Configuration
Item Description
Host name
Host name that identifies the ALL6900 on the network.
Domain name
Specifies the domain name of the ALL6900.
MAC Address
MAC address of the network interface.
Jumbo Frame Support
Enable or disable Jumbo Frame Support of the WAN interface on
your ALL6900.
DHCP
Enable or disable the ALL6900 from obtaining in IP address via
DHCP server. If you require a static IP, disable this feature and
input your network configuration.
IP
IP address of the WAN interface.
Netmask
Network mask, which is generally:
255.255.255.0
Gateway
Default Gateway IP address.
DNS Server
Domain Name Service (DNS) server IP address.
IP Sharing Mode
When enabled, PCs connected to the LAN port will be able to
access the WAN. Default is Enabled.
Link Aggregation
(ALL6900 only)
Specifies whether WAN and LAN ports will be aggregated and
act as one port.
Failover: When one port fails, the other one will take over.
Load Balance: Ethernet traffic will flow alternative between two
Ethernet ports.
802.3ad: Linkage two Ethernet ports in parallel to increase
throughput.
