Allied Vision MAKO G, Technical Manual

Page: 22 / 109

Specifications
22 Mako G Technical Manual V4.2.2
Absolute QE
Mass (typical) 80 g
Interface IEEE 802.3 1000BASE-T (Gigabit Ethernet), IEEE 802.3af (PoE)
Interface standard GigE Vision Standard V1.2
Camera control standard GenICam SFNC V1.2.1
Regulations CE, RoHS, REACH, WEEE, FCC, ICES
Temperature monitoring Available for main board only.
Resolution: 0.031; Accuracy: ± 1 °C
1
For more information on available optical filters see the Modular Concept.
2
These values are calculated directly from the microcontroller source. These values are only valid for pixel formats
< 16 bits per pixel and applicable in both Idle and Frame valid states:
•
Idle state: sensor is ready and camera is idle, waiting for the next trigger.
• Frame valid state: sensor is reading out and camera is busy. If next frame is requested by an external trigger in
this state, higher latency may occur as compared to the Idle state.
Figure 1: Mako G-030B, G-030C (CMOSIS CMV300) absolute QE
Feature
Specification
Mako G-030B Mako G-030C
Table 2: Mako G-030B, G-030C model specifications (continued)
0%
10%
20%
30%
40%
50%
60%
350 500 650 800 950 1100
Quan
tum
Efficiency
Wavelength [nm]
CMOSIS CMV300 absolute QE
All measurements were done without protection glass or IR cut filter.
With protection glass or filters, quantum efficiency (QE) decreases by approximately 10%.
The uncertainty in measurement of the QE is +/
Ͳ
10.25%.
The values are typical and are subject to minor variations.
Red QE Green QE Blue QE Monochrome QE