Installing the hardware
68
Alvium CSI-2 Cameras User Guide V1.1.0
Mounting the camera
Mounting bare board cameras
Schematic drawings in
show the Alvium CSI-2 bare board camera. Only
the mounting area (gray) can be used for mounting. The sensor/electronics area
(red) must not be touched nor put at mechanical stress.
a = Screw hole
b = Screw hole and chassis ground
1. Mount the bare board with four M2 screws at 0.1 Nm maximum torque.
Heat dissipation and housings for bare board cameras
For heat dissipation, see the
Optimum Heat Dissipation for Housed Alvium Cameras
application note.
For designing suitable camera housings, see the
FPC Cables and Embedded Boards
for Alvium CSI-2 Cameras
requirement specification.
For electromagnetic compatibility, see the
Electromagnetic Compatibility for Open
Housing Alvium Cameras
application note.
You can find all documents at
https://www.alliedvision.com/en/support/
technical-documentation/alvium-documentation.html
.
NOTICE
Damage to the camera by improper mounting
•
Allow mechanical contact only at the mounting area.
•
Avoid any mechanical stress to the sensor and the electronics area.
•
Avoid short circuits of the electronics components.
•
Give 2 mm minimum clearance above board components.
•
Tighten screws at 0.1 Nm maximum torque.
Figure 25: Mounting area of Alvium CSI-2 bare board cameras
connector side (left) | sensor side (right)
i
b
a
a
a
b
a
a
a
Top
