Allied Vision Technologies Prosilica GC1280, User Manual, Page: 8 / 28

GC1280 User Manual
70-0039A-C
AVT Inc.
6
Item 1: GIGABIT ETHERNET PORT
This port conforms to the IEEE 802.3 1000BASE-T standard for Gigabit Ethernet over copper.
It is recommended that CAT5E or CAT6 compatible cabling and connectors be used for best
performance. Cable lengths up to 100m are supported.
Item 2: General Purpose I/O PORT
1
2
3
5
7
6
4
8
9
10
11 12
PIN FUNCTION
1 Power Ground
2 12V Power
3 Sync Input 1 - isolated
4 Sync Output 1 - isolated
5 Isolated Ground
6 Video Iris
7 DNC
8 RS-232 TXD
9 RS-232 RXD
10 Signal Ground
11 Sync Input 2 – non-isolated
Figure 3. General Purpose I/O Pin out. Camera
rear view.
12 Sync Output 2 – non-isolated
The General Purpose I/O port uses a Hirose HR10A-10R-12PB connector on the camera side.
The mating cable connector is Hirose HR10A-10P-12S. This connector can be purchased from
Prosilica or from
http://www.digikey.com .
See Addendum for more detail.
DO NOT EXCEED 5.5V ON SIGNAL INPUTS UNLESS OTHERWISE
INDICATED. SYNC INPUT 1 CAN BE DRIVEN FROM A HIGHER VOLTAGE IF
A CURRENT LIMITING RESISTOR IS USED TO LIMIT THE CURRENT TO
LESS THAN 10 MILLIAMPS.
12V Power and Power Ground
To operate the camera 12V Power with suitable current capacity (see specifications) must be
provided on Pin 2 and the Power Ground on Pin 1.
A cable assembly providing this power can be ordered from Prosilica (Prosilica P/N 02-8003A
for North America or Prosilica P/N 02-8004A for a Universal supply).