C613-50170-01 Rev B
Command Reference for x510 Series
2342
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
A
LLIED
T
ELESIS
M
ANAGEMENT
F
RAMEWORK
™ (AMF) C
OMMANDS
SHOW
ATMF
AREA
NODES
show atmf area nodes
Overview
Use this command to display summarized information about an AMF controller’s
remote nodes.
Note that this command can only be run from a controller node.
Syntax
show atmf area nodes [<
area-name
> [<
node-name
>]]
Mode
Privileged Exec
Usage
If you do not limit the output to a single area or node, this command lists all remote
nodes that the controller is aware of. This can be a very large number of nodes.
Example
To show summarized information about all the nodes the controller is aware of,
use the command:
controller-1#
show atmf area nodes
The following figure shows partial example output from running this command.
Parameter
Description
<
area-name
>
Displays information about nodes in the specified area.
<
node-name
>
Displays information about the specified node.
Table 11:
Output from the
show atmf area nodes
command
controller-1#show atmf area nodes
Wellington Area Node Information:
Node Device ATMF Node
Name Type Master SC Parent Depth
----------------------------------------------------------------------------
well-gate x230-18GP N N well-master 1
well-master AT-x930-28GPX Y N none 0
Wellington node count 2
...
Table 12:
Parameter definitions from the
show atmf area nodes
command
Parameter
Definition
Node Name
The name assigned to a particular node.
Device Type
The Product series name.
