Allied Telesis x510-28GPX, Command Reference Manual

Page: 1749 / 2822

C613-50170-01 Rev B Command Reference for x510 Series 1749
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
A
UTHENTICATION
C
OMMANDS
AUTH TIMEOUT QUIET
-
PERIOD
auth timeout quiet-period
Overview This command sets a time period for which another authentication request is not
accepted on a given interface, after an authentication request has failed.
Use the no variant of this command to reset the quiet period to the default.
Syntax auth timeout quiet-period < 1-65535 >
no auth timeout quiet-period
Default The quiet period for port authentication is 60 seconds.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, or a
switch port; or Authentication Profile mode.
Examples To set the quiet period to 10 seconds for interface port1.0.2, use the following
commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# auth timeout quiet-period 10
To reset the quiet period to the default (60 seconds) for interface port1.0.2, use the
following commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# no auth timeout quiet-period
To set the quiet period to 10 seconds for authentication profile ‘student’, use the
commands:
awplus# configure terminal
awplus(config)# auth profile student
awplus(config-auth-profile)# auth timeout quiet-period 10
To reset the quiet period to the default (60 seconds) for authentication profile
‘student’, use the commands:
awplus# configure terminal
awplus(config)# auth profile student
awplus(config-auth-profile)# no auth timeout quiet-period
Related
Commands
auth profile (Global Configuration)
Parameter Description
< 1-65535 >
Specifies the quiet period (in seconds).