Allied Telesis x330 Series, Installation Manual

Page: 60 / 126

Chapter 3: Installing the x330-10GTX Switch in an Equipment Rack
60
Installing the x330-10GTX Switch
This section contains instructions for installing the x330-10GTX switch in a
standard 19-inch equipment rack with the optional RKMT-J05 equipment
rack brackets kit. Here are the required items:

One RKMT-J05 rack mount brackets kit (sold separately)

Phillips-head screwdriver (not provided)

Four standard equipment rack screws (not provided)
To install the switch in a 19-inch equipment rack with the RKMT-J05
equipment rack brackets kit, perform the following procedure:
1. Place the switch on a table.
Note
If the bumper feet are installed on the bottom panel of the switch,
remove them before continuing.
2. Unpack the RKMT-J05 equipment rack brackets kit and verify the
contents. Refer to Figure 19 on page 51.
3. Attach the handles in the RKMT-J05 kit to the short brackets using the
supplied M3x6mm pan head screws and a Phillips-head screwdriver.
Be sure to attach the handles to the correct sides of the short brackets
for your switch-brackets configuration. Refer to Figure 28. The handles
are optional.
Figure 28. Attaching the RKMT-J05 Handles to the Short Brackets