AT-S80 Version 2.3.1 Software Release Notes
PN 613-001276 Rev B
3
Allied Telesis, Inc.
Known Issues
The following issue was found in this release:
802.1x Guest VLAN - When 802.1x is used to authenticate a port and the guest VLAN
function is enabled, the port becomes a member of the guest VLAN permanently, even after a
reboot.
Resolved Issues
Default VLAN - Access to the Management port is now restricted to the default VLAN only as
is stated in the manual.
Fiber Combo Port -The fiber side of the combo port can now be changed between 1000 Mbps
and 100 Mbps on the Physical interface page and the Front Panel page. Previously, the
option on the Front Panel page didn’t work.
Combo Port Link State - The combo port link state is now properly displayed on the Front
Panel page when linked via 100FX.
Front Panel LED Display - The Front Panel page is now properly displayed the 100FX link on
each port.
Applying PVID via Web - Applying the certain PVID’s to a port when using the web interface
now succeeds and will result not in an error message.
Port Mirroring - Port Mirroring is now working properly.
Version 2.1.0
Hardware Features
None
Known Issues
The following issues were found in this release:
Default VLAN. The Management port can be accessed from any VLAN and is
not
restricted
to the default VLAN as is stated in the manual. This issue will be fixed in a future release.
Setting the Fiber Combo Port Type. On the web interface, the fiber side of a combo port (port
25 or port 26) can only be changed between 100FX and 1000X on the Physical Interface
page. If you try to change this parameter by selecting the Front Panel page by double clicking
on one of the fiber ports and attempting to change the Port Type, it only allows 1000X to be
selected.
Combo Port Link State. On the Front Panel web page, the combo port link state does not
display when linked via 100FX. See Figure 1, “Front Panel Web Page w/ 100FX Link” below.
