Allied Telesis TQ5403, Installation Manual, Page: 31 / 82

TQ5403 and TQm5403 Wireless Access Points Installation Guide
31
LEDs
The LEDs on the top panel display status information. They are defined in
Table 2.
Table 2. LED Status Information
LED State Description
Power
Green The access point is powered ON and
operating normally.
Red The device is booting up or it has
encountered a fault condition.
Blinking Red The access point is upgrading its
firmware.
Off The access point is not receiving
power.
LAN1
Green The port has established a link to a
network device.
Blinking Green The port is transmitting or receiving
data.
Off The port has not established a link to a
network device.
LAN2
Green The port has established a link to a
network device.
Blinking Green The port is transmitting and receiving
data.
Off The port has not established a link to a
network device.
2.4GHz
Wi-Fi Green
The 2.4GHz Radio1 is enabled.
Off
The 2.4GHz Radio1 is disabled.
5 GHz
1
Wi-Fi
Green
The 5GHz Radio2 is enabled.
Off
The 5GHz Radio2 is disabled.
5 GHz
2
Wi-Fi
Green
The 5GHz Radio3 is enabled.
Off
The 5GHz Radio3 is disabled.