Allied Telesis IS230-10GP, Web User Manual

Page: 66 / 136

IS230-10GP Industrial layer 2 Switch Web User Guide
67
The STP Port Status settings in the ensuing table are informational only:
Port, Enable, Path Cost, Edge Port and P2P MAC.
STP Bridge Settings
The STP Bridge Settings page allows you to configure the priority, forward
delay, maximum age, Tx hold count, and the hello time for the bridge.
To access this page, click
L2 Switching > Spanning Tree > STP Bridge
Settings .
Figure 43. L2 Switching > Spanning Tree > STP Bridge Settings
The following table describes the items in Figure 43.
Enable Select Enabled or Disabled to setup the profile for the STP port.
Path Cost (0 = Auto) Set the port’s cost contribution. For a root port, the root path cost for
the bridge. (0 means Auto).
Edge Port Click the drop-down menu to set the edge port configuration.
n
No: Force to false state (as link to a bridge).
n Yes: Force to true state (as link to a host).
P2P MAC Click the drop-down menu to set the Point-to-Point port configuration.
n
No: Force to false state.
n Yes: Force to true state.
Migrate Click the check box to enable the migrate function.
Forces the port to use the new MST/RST BPDUs, requiring the switch
to test on the LAN segment. for the presence of legacy devices, which
are not able to understand the new BPDU formats.
Apply Click Apply to save the values and update the screen.
Table 39. STP Port Settings (Continued)
Item Description
Table 40. STP Bridge Settings
Item Description
Priority Click the drop-down menu to select the STP bridge priority.